Today in Aviation History: First Flight of The Lockheed YF-104A Starfighter

Lockheed YF-104A, 55-2955. (AFFTC History Office)


by Bryan R. Swopes of This Day in Aviation

On February 17, 1956, test pilot Herman Richard (“Fish”) Salmon made the first flight of the Lockheed YF-104A service test prototype, Air Force serial number 55-2955 (Lockheed serial number 183-1001). This airplane, the first of seventeen pre-production YF-104As, incorporated many improvements over the XF-104 prototype, the most visible being a longer fuselage. On 28 February 1956, YF-104A 55-2955 became the first aircraft to reach Mach 2 in level flight. The YF-104A was later converted to the production standard and redesignated F-104A.

lockheed test pilots 1
Lockheed test pilots Anthony W. (“Tony”) LeVier, on the left, and Herman R. (“Fish”) Salmon, circa 1957. An F-104 Starfighter is in the background. (Jet Pilot Overseas)

The Lockheed F-104A Starfighter was a single-place, single-engine, Mach 2 interceptor. It was designed by a team led by the legendary Clarence L. “Kelly” Johnson. The F-104A is 54.77 feet (16.694 meters) long with a wingspan of 21.94 feet (6.687 meters) and an overall height of 13.49 feet (4.112 meters). The total wing area is just 196.1 square feet (18.2 square meters). At 25% chord, the wings are swept aft 18° 6′. They have 0° angle of incidence and no twist. The airplane has a very pronounced -10° anhedral. An all-flying stabilator is placed at the top of the airplane’s vertical fin, creating a “T-tail” configuration. The F-104A had an empty weight of 13,184 pounds (5,980.2 kilograms). The airplane’s gross weight varied from 19,600 pounds to 25,300 pounds, depending on the load of missiles and/or external fuel tanks.


Internal fuel capacity was 896 gallons (3,392 liters). With Sidewinder missiles, the F-104A could carry two external fuel tanks on underwing pylons, for an additional 400 gallons (1,514 liters). If no missiles were carried, two more tanks could be attached to the wing tips, adding another 330 gallons (1,249 liters) of fuel.

Lockheed YF 104A Starfighter 55 2955 183 1001
Lockheed YF-104A Starfighter 55-2955 (183-1001), right profile. Note the increased length of the fuselage and revised air intakes, compared to the XF-104, above. Also, the XF-104’s nose gear retracts backward, while the YF-104A’s gear swings forward. (U.S. Air Force)

The F-104A was powered by a single General Electric J79-GE-3B, -11A or -19 engine. The J79 is a single-spool, axial-flow, after-burning turbojet, which used a 17-stage compressor and 3-stage turbine. The J79GE-3B has a continuous power rating of 8,950 pounds of thrust (39.81 kilonewtons) at 7,460 r.p.m. Its Military Power rating is 9,600 pounds (42.70 kilonewtons) (30-minute limit), and 15,000 pounds (66.72 kilonewtons) with an afterburner (5-minute limit). The engine is 17 feet, 3.2 inches (5.263 meters) long, 2 feet, 8.6 inches (0.828 meters) in diameter, and weighs 3,225 pounds (1,463 kilograms). The F-104A had a maximum speed of 1,150 knots (1,323 miles per hour/2,130 kilometers per hour) at 35,000 feet (10,668 meters). The Starfighter’s initial rate of climb was 60,395 feet per minute (306.8 meters per second) and its service ceiling was 59,600 feet (18,166 meters).

Armament was one General Electric M61 Vulcan six-barreled revolving cannon with 725 rounds of 20 mm ammunition, firing at a rate of 4,000 rounds per minute. An AIM-9B Sidewinder infrared-homing air-to-air missile could be carried on each wing tip.


Lockheed built 153 of the F-104A Starfighter initial production version. A total of 2,578 F-104s of all variants were produced by Lockheed and its licensees, Canadair, Fiat, Fokker, MBB, Messerschmitt,  Mitsubishi and SABCA. By 1969, the F-104A had been retired from service. The last Starfighter, an Aeritalia-built F-104S ASA/M of the  Aeronautica Militare Italiana, was retired in October 2004.

Ritiro F 104 The lst F 104 Starfighter
The 9-ship formation was one of the highlights of the International F-104 Meeting in 2004. Photo by David Cenciotti

While conducting flame-out tests in 55-2955, 25 April 1957, Lockheed engineering test pilot John A. (“Jack”) Simpson, Jr., made a hard landing at Air Force Plant 42, Palmdale, California, about 22 miles (35 kilometers) southwest of Edwards Air Force Base. After a bounce, the landing gear collapsed, and the Starfighter skidded off the runway. 55-2955, nick-named Apple Knocker, was damaged beyond repair. “Suitcase” Simpson was not hurt.



This Day In Aviation

Moreno-Aguiari

Born in Milan, Italy, Moreno moved to the U.S. in 1999 to pursue a career as a commercial pilot. His aviation passion began early, inspired by his uncle, an F-104 Starfighter Crew Chief, and his father, a military traffic controller. Childhood adventures included camping outside military bases and watching planes at Aeroporto Linate. In 1999, he relocated to Atlanta, Georgia, to obtain his commercial pilot license, a move that became permanent. With 24 years in the U.S., he now flies full-time for a Part 91 business aviation company in Atlanta. He is actively involved with the Commemorative Air Force, the D-Day Squadron, and other aviation organizations. He enjoys life with his supportive wife and three wonderful children.

Array
About Moreno Aguiari 3365 Articles
Born in Milan, Italy, Moreno moved to the U.S. in 1999 to pursue a career as a commercial pilot. His aviation passion began early, inspired by his uncle, an F-104 Starfighter Crew Chief, and his father, a military traffic controller. Childhood adventures included camping outside military bases and watching planes at Aeroporto Linate. In 1999, he relocated to Atlanta, Georgia, to obtain his commercial pilot license, a move that became permanent. With 24 years in the U.S., he now flies full-time for a Part 91 business aviation company in Atlanta. He is actively involved with the Commemorative Air Force, the D-Day Squadron, and other aviation organizations. He enjoys life with his supportive wife and three wonderful children.

Be the first to comment

Graphic Design, Branding and Aviation Art

Leave a Reply

Your email address will not be published.


*